brass stair rods from stair rods uk
Tel: 01207 591176

Stair Rods UK
How to measure stair rods

 
Our Premier and Country brass stair rods are made to measure, so we need a tip to tip measurement for them, including the finial. Whilst the majority of the stair has a regular distance between the edge of the carpet and the stringboard or spindles, check to see if a newel post or other obstruction affects the required length of rod on that step. The guide below gives information on measuring and installing stair rods.

     

When measuring for stair rods, we have recommendations for the rod lengths:

All 1/2" (12.5mm) diameter rods, Tudor, Crystal, Vision, Homepride, Blacksmith Flat and Ball:
stair rods should be 4"/10cm over the width of the carpet (2"/5cm each side)

All 5/8" (16mm) diameter rods:
rods should be 5"/12.5cm over the width of the carpet (2.5"/6.25cm each side)

All 3/4" (19mm) diameter rods, Royale, Eastern Promise & Blacksmith Spear:
rods should be 6"/15cm over the width of the carpet (3"/7.5cm each side)
measuring stair rods
 
We recommend fitting a stair rod on the bottom step.
installing stair rods
 
When fitting Posh, Joints or Symwood, ensure the wings of the door thresholds are over the gripper as shown in fig. 3.
installing door thresholds

Installing Stair Rods

The bracket should sit on the stair case itself, directly alongside the carpet. Make bradawl guide holes for the screws and then screw the bottom half of the bracket to the stair. Do the same on the other side and then lay the stair rod in the brackets and screw the top half of the bracket to the bottom, ensuring the rod is protruding an equal amount on each end.

On no account should the top and bottom of each hinged bracket be mixed as they are a set, they cannot be interchanged with the other brackets, so we recommend not mixing the bracket components when preparing them for fitting. Note:Stair rods are for decorative use only, the carpet must be secured by another means.

 

Stair Rods FAQ's

Will our products need polishing?
No, all our brass products have a clear laquer that prevents them from tarnishing. To clean, simply wipe with a damp cloth. DO NOT use metal cleaning products as this will damage the laquer, causing tarnishing and damage to any finish you may have chosen.

Can stair rods be altered once ordered?
No. It is vital to carefully measure the rods before ordering to ensure the lengths are correct as they cannot be altered once they have been made.

Can the rods be used as the sole means of securing the carpet?
No, we strongly recommend that the carpet is installed by other means. Fitting the carpet correctly increases its lifespan and improves the safety of the stair case.